Aladdin Wick For No. 201 & 202 - P999907
No. 201& 202 Wick
Internal diameter: 46mm (1.820 inch) approx
External diameter: 52mm (2.0039 inch) approx
TO FIT A NEW WICK
Remove burner from tank.
Take out flame spreader (perforated cap in centre of burner).
Remove outer wick tube by turning anticlockwise and lifting.
Turn wick up fully and pull it out of burner with wick carrier.
(The burner is now ready for new wick to be fitted). Keep carrier and throw old wick away.
Pass paper tabs on new wick through the two semi-circular slots in burner base. Pull tabs until bottom of tape inside wick is just below top edge of centre tube.
With arms uppermost fit carrier to burner on winder side so that the rack slides over guide inside large tube.
Push carrier down until rack just engages with winder cog. Hold top of wick and turn winder anti-clockwise slowly until carrier arms engage with wick clips. Ensure that they are properly engaged then turn down wick.
Pull tails of wick evenly so that wick carrier rack engages with wick winder mechanism inside large tube. Turn down wick as far as possible.
Replace flame spreader (holes uppermost).
Replace outer wick tube by locking it under all three pips inside rim of burner.
Tear paper tabs from wick. Replace burner in tank. Fill container with paraffin and allow the new wick to soak for at least one hour before lighting.
USE ONLY GENUINE ALADDIN WICKS AS USING OTHER MAY RESULT IN POOR PERFORMANCE AND CAUSE PROBLEMS
Caravan Camping & Marine
95 Manchester Street
Near St Asaph Street
Phone: 03 366 0726
Fax: 03 366 0721